Plaster and Crack Repair
Spiderweb cracks, loose plaster and split seams, reattached and taped so they stay closed.
Cracked plaster, brown rings left by ice dams, popped screws and the holes a remodel leaves behind, repaired and blended so the patch disappears under your paint.
Most walls need less work than people expect. We tell you which kind of job yours is.
Your call goes to a local pro who looks at the wall and prices it before anything is touched.
Call 7 days, 7am–9pm
Basement and garage walls take a different kind of beating, and the verdict on most of them is simple: fix the cause, wait, then patch. Rushing the order is how people end up paying for the same strip of wall twice.
A finished basement is nearly always drywall over studs, even under a house whose upper floors are plaster, because the finishing came long after the house itself. When groundwater seeps in or a supply line drips behind the wall, the bottom few inches of board go soft and the paper face grows dark spots. Cutting that strip out while the source is still active only resets the clock.
The honest test is a moisture meter reading taken a few days apart. If the numbers keep falling, the wall is drying on its own and the repair can wait for it. If they hold, something is still feeding water in, and that has to be dealt with before anyone hangs new board.
Attached garages are their own case. The wall and ceiling between the garage and the living space are often built with fire-resistant Type X board, which is 5/8 inch thick and denser than ordinary wallboard. A hole from a car door or a pulled shelf bracket there should be closed with the same kind of board and taped tight, so the wall keeps doing the job it was built for.
Most garage damage is small in scope. A dented corner bead where the mower handle hits, a gouge behind the recycling bins, a fist-sized hole from a ladder: each is a short visit plus drying time between coats.
Most patch complaints are not really about the patch. They are about the paint on top of it. New compound absorbs paint at its own rate, unlike the sealed wall beside it, so the spot dries a little duller or a little shinier and shows every afternoon when the light comes in low across the wall.
Our blending guide explains why that happens and what fixes it: primer that evens out the surface, the right sheen, texture that matches what the rest of the wall has, and feathering the compound far wider than the damage. It is worth ten minutes before you open the paint can, whether you hire the repair out or do it yourself.
A few lines and a phone number are enough. Say which room, what the damage looks like and roughly how big it is. If there is a leak involved, say whether it has stopped.
Once this arrives, a nearby drywall pro looks it over and phones you to talk scope and price.
Four kinds of work cover most calls in and around Hershey. Each page explains what causes the damage, what a proper repair involves and what drives the price.
Spiderweb cracks, loose plaster and split seams, reattached and taped so they stay closed.
Brown rings from ice dams, tubs and roof leaks, sealed or cut out depending on how wet the board got.
Every hole the plumber, electrician or cabinet installer left, closed in one visit.
Doorknob holes, popped screws and anchor damage, reset and patched so the spot stays flat.
Compound is porous and paint is not forgiving, so the repaired spot has to be sealed before it gets color. A coat of primer over the patch stops it from drinking the paint and drying to a different finish than the wall around it.
Sheen is the next decision. Flat paint hides small ridges and edges well. Eggshell and satin show more, and semi-gloss shows almost everything. If your wall is satin, the patch needs to be sanded and feathered more carefully, because light will find any edge.
Texture comes before primer. Walls in newer houses often carry a light orange peel or knockdown, while plaster in older homes has a hand-troweled surface with soft waves in it. A smooth patch on a textured wall looks like a window in the paint, so the texture goes onto the patch first, worked until it resembles the wall around it.
Who paints is up to you. Plenty of people paint the patch themselves to save money, and that is a fair choice: prime the patch, then roll the whole wall from corner to corner rather than dabbing one spot. If you would rather the pro paint it, have the leftover can or the color code handy when you call.
Most jobs are in Hershey itself or elsewhere in Derry Township, Palmdale included, up in the township's northeast corner.
Hummelstown, about three and a half miles west of the center of Hershey, is a regular stop, and so is Campbelltown, just over the Lebanon County line on Hershey's eastern edge.
Farther east, Palmyra and Annville sit along the Lebanon Valley, and to the southwest Middletown runs along the Susquehanna River.
A sentence or two on each place sits on the page with every town in the coverage area.
A wet ceiling looks worse than it usually is. Take it in this order and most of the decisions make themselves.
Ice dams are behind a lot of winter stains. Heat from the house melts snow on the roof, the water runs down to the cold eave and freezes again, and the ridge of ice it builds holds back the next round of meltwater. That water works under the shingles and turns up overhead as a tea-colored ring close to an exterior wall, sometimes weeks after the storm.
The ceiling stain repair page goes further into testing a stained ceiling and what replacing a section involves.
| Spot patch | Cut out and replace a section | Skim coat the wall | |
|---|---|---|---|
| Fits when | The damage is a hole, crack or pop in otherwise sound wall | The board is soft, stained through or crumbling | A whole plaster wall is crazed with fine cracks |
| Wall touched | A few inches past the damage | Stud to stud or joist to joist | The entire wall face |
| Dust | Light, one small sanding area | Moderate, with a cut and new seams | The most, though wet sanding cuts it down |
| Coats and drying | Two or three thin coats | Tape, then three coats | Two or more full coats |
| Paint after | Prime the patch, paint the wall | Prime the section, paint the wall | Prime and paint the whole wall |
Legally, Hershey counts as an unincorporated community within Derry Township, Dauphin County. It has no borough government of its own, and the township provides its municipal services. Census figures for 2020 show 13,858 people in the Hershey census-designated place, and 24,717 in the township as a whole.
The original town was officially begun in 1903 and completed in 1905, and its houses were built with electricity, indoor plumbing and central heating from the start. Houses of that era were finished with plaster over wood lath, not drywall, and that shapes every repair in them: plaster cracks differently, it needs a different patch, and its hand-troweled surface has to be imitated rather than sprayed.
Away from the original streets, most of the township's homes went up later and are drywall throughout. By the 2000 census, Derry Township's count of dwellings stood at 9,481, and the newer ones bring the usual drywall problems: popped fasteners, seam cracks over doors and stained ceilings under bathrooms.
The township itself is far older than any of those houses. It was settled in 1717 and incorporated in 1729, and Swatara Creek forms most of its northwest border.
Tell us what you are looking at. If it is a small job, we will say so. If it is bigger than it looks, you will know that before anyone sands a thing. The page on how a repair runs from first call to fresh paint lays out each step.
Whichever way you reach out, a local pro follows up to see the damage and quote it first.
Call 7 days, 7am–9pm